Replacing Broken Piece Vinyl Siding

Cut out the damaged piece of siding leaving a space 2 inches shorter than the replacement piece.

Replacing broken piece vinyl siding.

Run a bead of adhesive caulk around the back of the patch and set the patch in place top image. Use a table saw or circular saw to cut a patch from a good piece of vinyl. Take the replacement board fit it in place image 2 and nail it in with a hammer using galvanized nails. Then lock the siding back into place.

Use the snips to cut away about two inches of the top nailing strip and the bottom j profile from both ends of the replacement piece. Work your hand into a seam between pieces then release the siding from the nailing strip. But if you need to replace a vinyl panel or part of a panel check your garage or basement to see whether the installer left extra pieces for repairs. Use tin snips to cut out the damaged area image 1.

Be sure to nail into the existing holes on the adjacent siding. Push the new piece into the nailing strip of the course below. Otherwise take a sample to a siding supplier and look for a close match. If a vinyl piece has come apart from its neighbor the solution is often to push it back up until it locks in place.

Install the replacement piece over the existing siding and attach with roofing nails. When replacing siding try to purchase a piece from the same manufacturer in the same color. The patch should be larger than the piece you removed. Subscribe to this old house.

Hold the loose undamaged piece of vinyl up and out of the way with one hand. Use a utility knife to cut the nailing strip off the top of a piece of matching siding that s larger than the hole or crack then attach it on top of the damaged piece with construction adhesive. Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes. Repairing large holes or cracks.

Nail straight down on the replacement board in order to hit studs. Another option is to use the zip tool to remove the damaged piece of vinyl siding and replace it with a new piece. With the other use the claw end of a hammer to pry up the nails holding the damaged piece of vinyl to the wall. Once all the nails are removed from the adjoining board the damaged one should just pull out.