Replacing Bathroom Faucet Supply Lines

Obviously this is important to prevent water leaks.

Replacing bathroom faucet supply lines.

The wrench allows you to reach into the cramped area behind the sink to loosen or tighten the nuts that hold the faucet to the sink and the nuts that connect the supply lines. Open the faucet to drain the line. Repeat on the other supply line. When cutting the supply line cut slowly and gently so.

Step 8 hook up the supply lines photo by kolin smith. Complete steps to replace bathroom sink water supply lines. Replace bathroom water supply lines without leaks. Pull out your new faucet and check the supply line connector supply lines usually won t come with your new faucet photo 2.

From underneath the sink tighten the base nuts to secure the new faucet. Get free shipping on qualified faucet connector supply lines or buy online pick up in store today in the plumbing department. Screw the inch fitting to the water shutoff valve. The supply lines tend to get mixed up.

Turn off the next valve up the line which may be the main water supply valve. Take your new faucet with you when you buy supply lines to make sure you get the right connector size. After you attach a faucet to the sink you can attach the water supply lines that will eventually be connected to the shut off valves on the main water supply pipes. Deburr the pipe with a deburring tool.

Place and secure the new faucet. With mine the water lines were attached to the new faucet but this isn t always the case. Regardless of what your supply line is made of it probably uses a coupling nut to secure it to the faucet tailpiece. Don t trust the labels on the shelf.

Now it s time to connect the faucet s water supply lines to the shut off valve beneath the sink. Place a bucket under the old valve. Depending on whether it s a kitchen or bathroom faucet you will need to either place the faucet directly into the mounting holes or feed the faucet lines into the holes. Simply screw the.

Disconnect the line and use a pipe cutter to cut along this mark. One of the biggest problems when swapping out water supply lines is knowing how tight the connections should be. Cut the supply line with a pipe cutter leaving enough room between the escutcheon plate and the cut to allow installation of the valve fitting. For braided supply lines.

Screw the inch compression fitting to the faucet valve.