Remove Deck Roof

Locate the rotted roof decking.

Remove deck roof.

Position the trash container for easy loading. How to fix rotted roof decking 1. Start by using a hammer and pry bar to remove the old deck boards. You also risk the potential of accidentally damaging the protective top layer of your roof shingles while trying to remove it with this method.

If it is next to a house or structure it should be secured to the siding or roof of that structure as well to keep it stable through high winds and lashing rains. Locate nails that hold shingles. If you re able to position it directly under one of the lower. If your deck was built with nails simply pull out the nails or pry the boards up with a hammer and a pry bar.

You can also insert a long board between the decking and joists to pry the old deck boards loose. Gain access to the attic to inspect the plywood or roof decking. Hose off the area with plain water spraying at a downward angle. Remove the shingles over the area of the rotted roof decking identified previously.

Start by removing all railings and stairs then move on to the deck boards. Gaf mastering the roof chapter 04 nothing is more critical in roofing than preparing the surface underneath the shingles. Pull off the top railings removing the balusters and bottom rails first. Look up at the roof.

If they are screwed together use a drill to reverse the screws. A free standing roof can be built over a deck paved patio or concrete pad. To remove deck boards without damaging them use a crowbar to pry them up if they are nailed together. Then use a long handled soft bristle scrub brush to remove the moss from the roof scrubbing from the top down to avoid lifting.

This involves disassembly with a utility bar a drill and bit set. Sometimes there can be hidden d. A free standing roof needs to have posts sunk into the ground. Remove the deck boards.

Removing lichen fully using this method is nearly impossible not to mention time consuming especially if you are dealing with a large surface like a roof. After all the old decking and nails have been removed pull a string or extend a straight board on edge across the floor joists to make sure the joists haven t sagged. A majority of decks nowadays are built with screws which are simple enough to remove with a drill or electric screwdriver. Detach the nails that.